20"/24“/26" Mountain Bike Modified Kit Front Wheel E-bike Conversion Kit

Description

新建网页 1
新建网页 1
Mountain Bike Modified Kit
The kit can help you to put his beloved mountain bike into a mountain electric bikes, it combines the advantages of mountain bike and electric cars, can meet the requirements of cycling exercise and be convenient for you  to travel and desire, at the same time, you can also through the process of self adapted mountain bike, enjoy the fun of DIY！
The kit is front wheel.
Battery is not included.
SKU
Voltage
Power
External dia.
(
After installing the tyre
)
141105
48V-60V
500W
20 inches
141106
48V-60V
500W
26 inches
141107
48V-60V
500W
24 inches
Installation instructions
1.
Install tires, disc brakes, motor wheels.
2. Install the battery and replace the speed control handle.
3. Wiring the controller, install the controller hanging bag.
Controller
W
iring
M
ethod
1. Turn off the power supply and the switch lock.
2. Connect the Hall wire, motor phase wire, switch lock wire, throttle handle wire,identification wire, and power wire in order to start debugging.
3.
Turn on the switch and the motor starts to rotate. If the wheel rotates in a forward direction, the debugging is successful; if the wheel rotates in a reverse direction, unplug the identification wire and connect it again until it turns in the forward direction and the debugging is successful.
4. After the debugging is successful, separate the two identification wire, turn the knob to confirm the success, turn off the switch, and connect other wires as needed. (When the motor is rotating forward, separate the identification wire without turning off the power supply, the motor will stop rotating, and the motor will be fully controlled by the handle at this time. Turn off the power supply and the commissioning is completed.)
Note
1.
Electric bicycles use direct current, the positive and negative poles of the power supply must be connected correctly (red is the positive pole, and black is the negative pole).
2.
Make sure the current is no smaller  than 20A or the motor will not work.
3.
Install circle is the most easy to appear problem, if the disc brake and disc brake device is not aligned, you can through the gasket to adjust.
4. The color of the handle may not be the same as shown in the picture.
Item Included:
1 Set of 20 Inch Mountain Bike Modified Kit  (141105)
or
1 Set of 26 Inch Mountain Bike Modified Kit (141106)
or
1 Set of 24 Inch Mountain Bike Modified Kit (141107)
On Jun-24-21 at 19:57:08 PDT, seller added the following information: