12 Volt Power Adapter for 1999-2022 Jeep Wrangler JK JKU JL JLU TJ Gladiator JT

Description

【Application】
Compatible with 2018~2021 Jeep Wrangler JL & Gladiator JT 2/4 doors.
【Funtion】
With this 12-volt power adapter, you can add accessories that are switched by the ignition switch to operate the accessories, such as CB radio, radar detector, portable GPS, satellite radio, auxiliary lighting, etc.
【No Splicing Required 】
This 12-volt power adapter is a direct plug-and-play solution that demands no other modifications. This convenient design allows you to easily power accessories in your vehicle.
【Easy to Use】
The only switched ignition lead available to tap into is located behind the lower dash power port. This is the only place that a switched accessory can safely be attached. This is an easy way to add accessories without causing damage to the electrical system.
【100% Satisfaction Guarantee】
If you're not 100% satisfied with our item, simply return it for a full refund in 60 days. Support 12 months’ Warranty.
Product description
Application:
For 1999-2022 Jeep Wrangler JK JL TJ Unlimited Sport Freedom Rubicon Sahara and Gladiator JT 2-Door and 4-Door all models.
For 2001-2021 Chrysler 300
For 2008-2020 Chrysler 300C
For 2004-2021 Chrysler Pacifica
For 2004-2021 Chrysler Voyager
For 2001-2016 Chrysler Town & Country
For 2001-2020 Ram 1500 2500 3500
For 2008-2021 Dodge Challenger
For 2007-2021 Dodge Charger
For 2009-2020 Dodge Journey
Upgrade Design
The wiring harness adds a series fuse and connection point to the factory's 12-volt power socket. Using this 12-volt power adapter, add an accessory power supply with switchable ignition switch to operate CB radio, radar detector, portable GPS, satellite radio, auxiliary lighting and other accessories.
No stitching requirements
This 12-volt power adapter is a direct plug-and-play solution that demands no other modifications. This convenient design allows you to easily power Jeep accessories.
Powerful functions
12 Volt Power Adapter can run two accessories at once as long as the total current draw is under 10 amps.
It allows you to neatly wire accessories that are switched on and off with the ignition key.
INSTALLATION INSTRUCTION
1.Using a Trim stick or flat edge screw driver, remove the dash panel below the steering column.
2.Unsnap the upper heater control panel and unplug the wiring.Remove the panel.
3. Using a phillips screw driver, remove the screw holiding the window control panel.
4. Fold the panel forward.Unplug the gray connnector on the power port located on the drivers side of the window control panel.
5.Take the gray connnector and plug it into the large white connector of the power tap.
6.Plug the small gray connector on the accessory power tap back into the power port on the window control panel.
7. Pull back the carpet on the passenger side of the console.Remove the plastic cap covering the console bolt and remove the bole. This will allow access for the terminal block to the fed through.
8.Route the white termial block and fuse holder on the power tap down through the small hole in the lower center section of the dash toward the passenger side coner of the dash as highlighted.(Take your time and have patience, it is a tight fit)
9.The white terminal block will end up under the carpet at the bottom of the console.This will be an easily accessible location for any future connnections you need to make.
10.Reassemble the dash.
Package Included
1X 12 Volt Power Adapter